Tesa 6940 Rapid laser film 120mmx200m, 0.140mm, black/white (glossy) PV06

The 3M cold shrink yarns for medium voltage series QT II are used to insulate all plastic or rubber insulated cables. The products are supplied pre-stretched on a removable support spiral, enabling efficient and simple installation. An electrical field control integrated into the insulating body simplifies installation. Due to the specific properties of the insulating silicone body, a wide range of cable cross-section terminations are possible. The 3M termination sets for medium voltages are available both with and without mechanical lugs. 3M cold shrink fittings for medium voltage have been developed as a simple and safe solution for terminating medium voltage cables. One-piece creep-resistant cold-shrink termination made of HTV silicone rubber suitable for all plastic-insulated 1-conductor cables in accordance with VDE and TGL.

This pendulum surface grinding wheel ensures universal use on high-alloy steels and HSS. This is achieved through the use of special aluminium oxides and mixtures with sintered aluminium oxides combined with special bond systems. The highest cutting performance can be achieved with sintered aluminium oxide compounds such as 454A. The next higher quality level is the resin-bonded VIB-STAR CBN wheel from TYROLIT.

S-K-S 3809 has good processing and die-cutting properties. This makes it very suitable for self-adhesive labelling of a wide variety of elements. The adhesive tape has a high initial tack and can be used on many high-energy surfaces.

Get a fast and even cut for numerous applications with the 3M Silver cutting disc. It cuts quickly through metal tubes, sleeves, flat sheets and other workpieces. The disc contains our precision grain, which has continuously sharp cutting edges, so it cuts through the material rather than scraping or ploughing through it like conventional abrasive grains. This results in a significantly longer service life than conventional abrasives with ceramic grit and a consistently stable high cutting rate over the service life. The disc must be used with an angle grinder or cut-off machine (available separately) and should always be used with a protective cover for safety reasons. The maximum speed of the disc must be greater than or equal to the maximum speed of the angle grinder.

With the 3M Accuspray nozzle heads from the 3M Accuspray system, you can optimise the filler application process in every respect. In just three simple steps, you can replace a nozzle head on the corresponding 3M Accuspray gun and have a completely clean device in your hand in just 30 seconds. Together with the 3M PPS cup system, a material change is possible within a very short time and time-consuming cleaning of the filler gun is a thing of the past. So every application feels like using a brand new spray gun. Thanks to the optimised spray jet of the nozzle heads and the modern HVLP technology of the gun, you achieve a smooth filler surface, an ideal layer thickness and significantly less spray mist during application. Your immediate benefit is a considerable reduction in the amount of work required, as the sanding time required in the subsequent process is minimised. You also reduce material consumption and your health risks. The 3M Accuspray nozzle heads are available in three different diameters: 1.4 millimetres (orange), 1.8 millimetres (white) and 2.0 millimetres (red). In combination with the 3M Accuspray HGP pressure cup gun, all nozzles are also suitable for highly viscous materials.

3M 618 is an excellent lacquer sanding tool on A-paper backing. Its open silicon carbide grit scattering and dust-repellent coating prevent premature clogging. It can be used both by hand and on orbital sanders.